1978-1988 A/G-Body Rear Trailing Arm Fastener Set
$22.99
Includes
-8x Grade 8 1/2-13 bolts
-8x Grade 8 1/2-13 nylon insert nuts
-16x Grade 8 1/2 SAE flat washers
All yellow zinc coated for rust prevention
Torque to 75 lb/ft
Note: The factory fastener size was 12mm, meaning the holes are a hair(<.020) smaller than the fasteners, a 1/2″ drill bit will make very quick work of those holes and allow the install of these fasteners. Stock or otherwise M12 fasteners will work but our arms have 1/2″ ID bushing sleeves and holes.
| Weight | 3 lbs |
|---|
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
Related products
-
1978-1988 A/G-Body Pre-Bent Stainless Steel Rear Hard Lines For Disc Brake Upgrade On Factory Rear
$44.99Quick ViewAdd to cart>Eliminates need to shorten factory lines >Pre-bent for a perfect fit >Pre-flared for a truly bolt on design >Stainless steel to last a lifetime Note: Must be used with the stainless braided line upgrade, standard hoses in the disc brake upgrade kit are too short *Actual part not shown
-
1978-1988 A/G-Body Disc/Disc Adjustable Combination (Proportioning) Valve Upgrade
$82.99Quick ViewAdd to cartDirectly bolts in place of factory unit Aftermarket combination valve, for cars with rear disc brake upgrades Allows adjustment of rear pressure to better match the front brakes Comes with bleed tool included TOO MUCH REAR BRAKE CAN BE A SAFETY HAZARD
-
1978-1988 A/G-Body Adjustable Front Upper Control Arms
$524.99Quick ViewAdd to cartThe most affordable adjustable upper control arm on the market, in fact most competitors’ non adjustable arms are hundreds more 6061-t6 adjustment tubes Teflon (PTFE) lined chromoly rod ends for maximum life and minimum friction 7075 forged aluminum cross shaft Integral ball joint holder offers smaller and lighter packaging +1” Howe ball joints improve camber …
1978-1988 A/G-Body Adjustable Front Upper Control ArmsRead More
-
1978-1988 A/G-Body MCP Rear Disc Brake Kit Caliper Spacer Upgrade
$19.99Quick ViewAdd to cartAllows the caliper piston to remain square in its bore by taking up the difference between the caliper designed for 1″ rotors and the aftermarket .810″ thick rotor Results in more even pad wear and therefore longer pad life A must for expensive pads, protect your investment!
Reviews
There are no reviews yet.