Eliminate the rubber rag joint that came stock on your 2nd gen S-10
Firm up your S-10s steering significantly and eliminate slop, all while making more room for your header tubes
A must for a vehicle with header clearance issues
Installs between the upper steering shaft and steering box
Interchanges with, and is more affordable than
-Hooker 71223021HKR
These U-joints are sealed and do not require grease. The plastic factory dust shield can be retained to keep dirt and other contaminates out of the assembly. An occasional shot of our rod end spray lube will keep them friction free for years.
Weight | 3 lbs |
---|---|
Dimensions | 2 × 3 × 17 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Rod End Spray by WD-40
$9.99Quick ViewAdd to cart> Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc
Related products
-
1982-2002 2WD S-10 Large Bore Front Calipers
$149.99Quick ViewAdd to cartSold as a pair Unidirectional, be sure to install the bleeder pointing up Large bore front calipers have been redesigned to not only be lighter but stronger than the stock unit These all new calipers deliver over 20% more clamping force at the rotor, much more than the popular but expensive “Blazer” upgrade Maintaining stock …
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
-
1994-2002 S-10 Steering U-Joint
$64.99Quick ViewAdd to cartEliminate the rubber rag joint that came stock on your 2nd gen S-10 Firm up your S-10s steering significantly and eliminate slop A must for a corner carver Installs between the steering shaft and steering box Replaces MANY stock rag joints on different applications using Lares PN 200 Interchanges with, and is more affordable than …
-
GM U-Joint Steering Shaft Assembly ’79+
$109.99Quick ViewAdd to cartImportant: Verify your steering box input spline is 3/4-30 spine, if not it is most likely 13/16-30 spline which was ’77 and earlier Eliminate the worn rubber rag joint that came stock on your classic Firm up your steering significantly and eliminate slop, all while making more room for your header tubes A must for …
Reviews
There are no reviews yet.