Sold in pairs
When replacing upper trailing arms be sure to check the condition of your upper housing bushings
Rubber allows a good bit of articulation while still absorbing a large amount of harshness from the road
New parts at OEM quality to replace worn and cracked factory rubber
Fits
64-67 68-72 73-77 78-88 midsize A/G-Body cars, all 8 rear end bushings are the same in the 4 arms
82-92 93-02 F-Body lower trailing arms
Weight | 5 lbs |
---|---|
Dimensions | 6 × 6 × 6 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
Related products
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
-
1978-1988 A/G-Body Disc/Disc Adjustable Combination (Proportioning) Valve Upgrade
$82.99Quick ViewAdd to cartDirectly bolts in place of factory unit Aftermarket combination valve, for cars with rear disc brake upgrades Allows adjustment of rear pressure to better match the front brakes Comes with bleed tool included TOO MUCH REAR BRAKE CAN BE A SAFETY HAZARD
-
Steering Link Bump Steer Spacers For Increased Accuracy
$15.99Quick ViewAdd to cartIncludes one pair each of .100″, .060″, .030″ spacers Increased accuracy to further adjust and reduce your bump steer, if needed One set does one car
-
1978-1988 A/G-Body Pre-Bent Stainless Steel Rear Hard Lines For Disc Brake Upgrade On Factory Rear
$44.99Quick ViewAdd to cart>Eliminates need to shorten factory lines >Pre-bent for a perfect fit >Pre-flared for a truly bolt on design >Stainless steel to last a lifetime Note: Must be used with the stainless braided line upgrade, standard hoses in the disc brake upgrade kit are too short *Actual part not shown
Reviews
There are no reviews yet.