1982-1992 F-Body Front Drilled / Slotted Rotor Upgrade
$99.99
Sold as a pair
Upgrade the look of your ride with our drilled and slotted slotted rotors
Direct bolt on with simple installation steps
Does include tone ring for vehicles equipped with ABS
*These are NOT recommended for actual track use as high heat will cause cracking around the holes
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Semi-Metallic Pads
$22.99Quick ViewAdd to cartDont upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your brakes. Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are needed …
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
Related products
-
GM U-Joint Steering Shaft Assembly ’79+
$109.99Quick ViewAdd to cartImportant: Verify your steering box input spline is 3/4-30 spine, if not it is most likely 13/16-30 spline which was ’77 and earlier Eliminate the worn rubber rag joint that came stock on your classic Firm up your steering significantly and eliminate slop, all while making more room for your header tubes A must for …
-
1982-1992 F-Body MCP Rear Disc Brake Kit Caliper Spacer Upgrade
$19.99Quick ViewAdd to cartAllows the caliper piston to remain square in its bore by taking up the difference between the caliper designed for 1″ rotors and the aftermarket .810″ thick rotor Results in more even pad wear and therefore longer pad life A must for expensive pads, protect your investment!
-
Sway Bar Rod-End End-Links
$64.99Quick ViewAdd to cartUsing a rod end to eliminate 2 bushings not only stiffens the rate of the sway bar, it also allows the end link to articulate more easily 6.5″ from control arm mount to sway bar mount -Teflon (PTFE) lined chromoly rod ends -Grade 8 fasteners -Custom CNC laser cut and bent steel bracket -Polyurethane bushings …
-
Large Bore Clip-In Wheel Cylinders For GM Drum Brakes
$35.99Quick ViewAdd to cartSold as a pair Increases stopping power of stock drum brakes significantly and noticeably Direct replacement for any “Clip-type” GM wheel cylinder Known fitment includes but is not limited to: >1978-1988 A/G-Body (Metric Chassis) >1982-1992 F-Body (factory drum rear) >1982-1990 S-10 / Sonoma
Reviews
There are no reviews yet.