Sold as a pair
Unidirectional, be sure to install the bleeder pointing up
Large bore front calipers have been redesigned to not only be lighter but stronger than the stock unit
These all new calipers deliver over 20% more clamping force at the rotor, much more than the popular but expensive “Blazer” upgrade
Maintaining stock dimensions allows serious brake power without needing to change to oversize wheels
Included in our performance brake kits for both parking brake and non-parking brake applications
Unlike almost every other front brake upgrade, these calipers are a direct bolt on. No machining or cutting required
Note: In very high heat applications we recommend removing the 4 O-rings in each caliper that ride on the slide pin
Weight | 10 lbs |
---|---|
Dimensions | 8 × 8 × 8 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Semi-Metallic Pads
$22.99Quick ViewAdd to cartDont upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your brakes. Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are needed …
-
MCP Speed Bleeders
$12.99Quick ViewAdd to cart>Fit stock front calipers for 1978-1988 A/G-Bodies, 1982-1992 F-Body front calipers, 1982-2002 2WD S-10 front calipers, and MCP rear disc upgrades for A/G-Bodies >Allows bleeding with only one person >Simply crack the bleeder as normal and it will allow fluid out but not suck air back in >Tighten when finished
-
1982-1992 F-Body DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)
$94.99Quick ViewAdd to cartIncludes frame to rear end hose that most kits do not A must for any vehicle with rubber hoses as they swell, reducing stopping power and making the car pull to one side under braking (sound familiar?) Will significantly increase brake pedal feel The absolute best bang for your buck, inexpensive brake upgrade you can …
1982-1992 F-Body DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)Read More
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
Related products
-
1982-1992 F-Body MCP Rear Disc Brake Kit Caliper Spacer Upgrade
$19.99Quick ViewAdd to cartAllows the caliper piston to remain square in its bore by taking up the difference between the caliper designed for 1″ rotors and the aftermarket .810″ thick rotor Results in more even pad wear and therefore longer pad life A must for expensive pads, protect your investment!
-
1982-1992 F-Body MCP Rear Disc Brake Kit Drilled / Slotted Rotor Upgrade
$79.99Quick ViewAdd to cartUpgrade your MCP rear disc brake kit to include drilled and slotted rotors *These are NOT recommended for actual track use as high heat will cause cracking around the holes
-
GM Rubber Trailing Arm Bushings 1964-2002
$9.99Quick ViewAdd to cartSold in pairs When replacing upper trailing arms be sure to check the condition of your upper housing bushings Rubber allows a good bit of articulation while still absorbing a large amount of harshness from the road New parts at OEM quality to replace worn and cracked factory rubber Fits 64-67 68-72 73-77 78-88 midsize …
-
GM U-Joint Steering Shaft Assembly ’79+
$109.99Quick ViewAdd to cartImportant: Verify your steering box input spline is 3/4-30 spine, if not it is most likely 13/16-30 spline which was ’77 and earlier Eliminate the worn rubber rag joint that came stock on your classic Firm up your steering significantly and eliminate slop, all while making more room for your header tubes A must for …
Reviews
There are no reviews yet.