1994-2002 S-10 Steering Shaft Assembly
$84.99
Eliminate the rubber rag joint that came stock on your 2nd gen S-10
Firm up your S-10s steering significantly and eliminate slop, all while making more room for your header tubes
A must for a vehicle with header clearance issues
Installs between the upper steering shaft and steering box
Interchanges with, and is more affordable than
-Hooker 71223021HKR
These U-joints are sealed and do not require grease. The plastic factory dust shield can be retained to keep dirt and other contaminates out of the assembly. An occasional shot of our rod end spray lube will keep them friction free for years.
| Weight | 3 lbs |
|---|---|
| Dimensions | 2 × 3 × 17 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Rod End Spray by WD-40
$9.99Quick ViewAdd to cart> Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc
Related products
-
GM U-Joint Steering Shaft Assembly ’79+
$109.99Quick ViewAdd to cartImportant: Verify your steering box input spline is 3/4-30 spine, if not it is most likely 13/16-30 spline which was ’77 and earlier Eliminate the worn rubber rag joint that came stock on your classic Firm up your steering significantly and eliminate slop, all while making more room for your header tubes A must for …
-
1982-2002 A/4WD S-10 Adjustable Off-Road Steering Link Kit
$239.99Quick ViewAdd to cartTeflon (PTFE) lined chromoly rod ends for maximum life and minimum friction High travel rod ends offer 15° more travel in either direction than a standard rod end (maximum pin to adjustment tube misalignment 32°) High quality Moog brand inner tie rods, with 90 degree grease zerk for ease of maintenance All needed fasteners included …
1982-2002 A/4WD S-10 Adjustable Off-Road Steering Link KitRead More
-
1991-2002 2WD S-10 DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)
$69.99Quick ViewAdd to cartA must for any vehicle with rubber hoses as they swell, reducing stopping power and making the car pull to one side under braking Will significantly increase brake pedal feel The absolute best bang for your buck, inexpensive brake upgrade around. NOTE: Check the wrench size of your front flare nuts (nut on the …
1991-2002 2WD S-10 DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)Read More
Reviews
There are no reviews yet.