Archives: Performance Shop
Showing 109–119 of 119 resultsSorted by price: high to low
-
1982-1992 F-Body MCP Rear Disc Brake Kit Caliper Spacer Upgrade
$19.99Quick ViewAdd to cartAllows the caliper piston to remain square in its bore by taking up the difference between the caliper designed for 1″ rotors and the aftermarket .810″ thick rotor Results in more even pad wear and therefore longer pad life A must for expensive pads, protect your investment!
-
1978-1988 A/G-Body MCP Rear Disc Brake Kit Caliper Spacer Upgrade
$19.99Quick ViewAdd to cartAllows the caliper piston to remain square in its bore by taking up the difference between the caliper designed for 1″ rotors and the aftermarket .810″ thick rotor Results in more even pad wear and therefore longer pad life A must for expensive pads, protect your investment!
-
Steering Link Bump Steer Spacers For Increased Accuracy
$15.99Quick ViewAdd to cartIncludes one pair each of .100″, .060″, .030″ spacers Increased accuracy to further adjust and reduce your bump steer, if needed One set does one car
-
Replacement Standard Brake Pad MPC Rear Kit
$14.99Quick ViewAdd to cartStandard, affordable pad, that comes in our rear disc kit. Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are needed to do the front and rear of the vehicle
-
GM Combination (Proportioning) Valve Bleed Tool
$12.99Quick ViewAdd to cartA must have tool to bleed a factory style disc/drum or disc/disc combination valves *May come in variety of colors depending on supplier stock
-
MCP Speed Bleeders
$12.99Quick ViewAdd to cart>Fit stock front calipers for 1978-1988 A/G-Bodies, 1982-1992 F-Body front calipers, 1982-2002 2WD S-10 front calipers, and MCP rear disc upgrades for A/G-Bodies >Allows bleeding with only one person >Simply crack the bleeder as normal and it will allow fluid out but not suck air back in >Tighten when finished
-
GM Rubber Trailing Arm Bushings 1964-2002
$9.99Quick ViewAdd to cartSold in pairs When replacing upper trailing arms be sure to check the condition of your upper housing bushings Rubber allows a good bit of articulation while still absorbing a large amount of harshness from the road New parts at OEM quality to replace worn and cracked factory rubber Fits 64-67 68-72 73-77 78-88 midsize …
-
Rod End Spray by WD-40
$9.99Quick ViewAdd to cart> Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc
-
Ball Joint Grease
$9.99Quick ViewAdd to cartRust and oxidation inhibitors Water resistant Excellent stability Long storage life We highly recommend you use this grease for our uppers, and give them a squirt of grease often (remember to wipe underneath so grease isn’t everywhere)
-
10/12 Bolt Backing Plate / Dust Shield Pair For MCP Conversion Kits
Quick ViewRead moreComplete your disc conversion with backing plates for a true factory look. Designed to fit any of our 10/12 bolt kits with the exception of the S-10, G-body, and drum brake F-body conversion kits.
-
1982-2002 2WD S-10 Performance Disc Brake Kit for 8.8 Explorer Swap
Quick ViewRead moreWhether your S-10 was originally equipped with rear disc brakes, you swapped to a factory style rear disc, or you already installed our MCP rear disc brake kit you still have room to improve your brake system. Includes: -DOT approved braided hoses for the front and our exclusive MCP brake hose kit for 8.8 swaps …
1982-2002 2WD S-10 Performance Disc Brake Kit for 8.8 Explorer SwapRead More