Category: 1978-1988 A/G-Body
1978-1988 A/G-Body
Showing 13–24 of 31 results
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
-
Saginaw Manual Box Swap Pitman Arm
$49.99Quick ViewAdd to cartThe proper geometry pitman arm for a manual box swap on many GM vehicles. A pitman arm from a power box will not fit a manual box as the output shaft sizes are different Brand new, with black a E-coat finish Fits 1982-1992 F-Bodies 1978-1988 G-Bodies 1982-2002 2WD S-10s With manual box swaps
-
1978-1988 A/G-Body Pre-Bent Stainless Steel Rear Hard Lines For Disc Brake Upgrade On Factory Rear
$44.99Quick ViewAdd to cart>Eliminates need to shorten factory lines >Pre-bent for a perfect fit >Pre-flared for a truly bolt on design >Stainless steel to last a lifetime Note: Must be used with the stainless braided line upgrade, standard hoses in the disc brake upgrade kit are too short *Actual part not shown
-
Large Bore Clip-In Wheel Cylinders For GM Drum Brakes
$35.99Quick ViewAdd to cartSold as a pair Increases stopping power of stock drum brakes significantly and noticeably Direct replacement for any “Clip-type” GM wheel cylinder Known fitment includes but is not limited to: >1978-1988 A/G-Body (Metric Chassis) >1982-1992 F-Body (factory drum rear) >1982-1990 S-10 / Sonoma
-
1978-1988 A/G-Body Pre-Bent OEM Steel Rear Hard Lines For Disc Brake Upgrade On Factory Rear
$34.99Quick ViewAdd to cartEliminates need to shorten factory lines Pre-bent for a perfect fit Pre-flared for a truly bolt on design Note: Must be used with the stainless braided line upgrade, standard hoses in the disc brake upgrade kit are too short *Actual part not shown
-
GM Polyurethane Trailing Arm Bushings 1964-2002
$34.99Quick ViewAdd to cartSold in pairs When replacing upper trailing arms be sure to check the condition of your upper housing bushings Polyurethane offers a tighter suspension feel while still eliminating a moderate amount of road harshness New parts to replace worn and cracked factory rubber Fits >64-67 68-72 73-77 78-88 midsize A/G-Body cars, all 8 rear end …
-
1978-1988 A/G-Body Rear Trailing Arm Fastener Set
$22.99Quick ViewAdd to cartIncludes -8x Grade 8 1/2-13 bolts -8x Grade 8 1/2-13 nylon insert nuts -16x Grade 8 1/2 SAE flat washers All yellow zinc coated for rust prevention Torque to 75 lb/ft Note: The factory fastener size was 12mm, meaning the holes are a hair(<.020) smaller than the fasteners, a 1/2″ drill bit will make very …