1978-1988 A/G-Body Large Bore Front Calipers
$149.99
Sold as a pair
Unidirectional, be sure to install the bleeder pointing up
Large bore front calipers have been redesigned to not only be lighter but stronger than the stock unit
These all new calipers deliver over 20% more clamping force at the rotor, much more than the popular but expensive “Blazer” upgrade
Maintaining stock dimensions allows serious brake power without needing to change to oversize wheels
Included in our performance brake kits for both parking brake and non-parking brake applications
Unlike almost every other front brake upgrade, these calipers are a direct bolt on. No machining or cutting required
Note: In very high heat applications we recommend removing the 4 O-rings in each caliper that ride on the slide pin
| Weight | 10 lbs |
|---|---|
| Dimensions | 8 × 8 × 8 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Semi-Metallic Pads
$22.99Quick ViewAdd to cartDont upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your brakes. Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are needed …
-
1978-1988 A/G-Body DOT Approved Stainless Steel Braided Brake Hose Kit
$84.99Quick ViewAdd to cartIncludes frame to rear end hose that most kits do not A must for any vehicle with rubber hoses as they swell, reducing stopping power and making the car pull to one side under braking Will significantly increase brake pedal feel The absolute best bang for your buck, inexpensive brake upgrade around
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
Related products
-
1978-1988 A/G-Body Rear Trailing Arm Fastener Set
$22.99Quick ViewAdd to cartIncludes -8x Grade 8 1/2-13 bolts -8x Grade 8 1/2-13 nylon insert nuts -16x Grade 8 1/2 SAE flat washers All yellow zinc coated for rust prevention Torque to 75 lb/ft Note: The factory fastener size was 12mm, meaning the holes are a hair(<.020) smaller than the fasteners, a 1/2″ drill bit will make very …
-
GM Monoball Trailing Arm Bushings 1964-2002
$99.99Quick ViewAdd to cartSold in pairs When replacing upper trailing arms be sure to check the condition of your upper housing bushings Monoballs offer friction free articulation between the limits of their travel, with the drawback being increased road vibrations New parts to replace worn and cracked factory rubber Fits >64-67 68-72 73-77 78-88 midsize A/G-Body cars, all …
-
Universal Proportioning Valve
$42.99Quick ViewAdd to cartUniversal proportioning valve placed in-line with the rear hard line will modulate the rear brakes Rear brakes applying harder and locking before the front is extremely dangerous and when installed and adjusted right this helps to eliminate that
-
1978-1988 A/G-Body MCP Rear Disc Brake Kit Caliper Spacer Upgrade
$19.99Quick ViewAdd to cartAllows the caliper piston to remain square in its bore by taking up the difference between the caliper designed for 1″ rotors and the aftermarket .810″ thick rotor Results in more even pad wear and therefore longer pad life A must for expensive pads, protect your investment!
Reviews
There are no reviews yet.