Sold as a pair
Unidirectional, be sure to install the bleeder pointing up
Large bore front calipers have been redesigned to not only be lighter but stronger than the stock unit
These all new calipers deliver over 20% more clamping force at the rotor, much more than the popular but expensive “Blazer” upgrade
Maintaining stock dimensions allows serious brake power without needing to change to oversize wheels
Included in our performance brake kits for both parking brake and non-parking brake applications
Unlike almost every other front brake upgrade, these calipers are a direct bolt on. No machining or cutting required
Note: In very high heat applications we recommend removing the 4 O-rings in each caliper that ride on the slide pin
You may also like…
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
-
1978-1988 A/G-Body Performance Disc Brake Kit W/ Parking Brake
$549.99Quick ViewAdd to cartOutpacing (or out-stopping) this kit requires thousands of dollars Includes our rear disc kit w/ parking brake Braided hoses for the front and frame to rear end to tighten brake feel Large bore front calipers deliver more clamping force to the rotor Brand new, non-junkyard parts Note: The MCP rear disc brake conversion included in …
1978-1988 A/G-Body Performance Disc Brake Kit W/ Parking BrakeRead More
-
1978-1988 A/G-Body DOT Approved Stainless Steel Braided Brake Hose Kit
$84.99Quick ViewAdd to cartIncludes frame to rear end hose that most kits do not A must for any vehicle with rubber hoses as they swell, reducing stopping power and making the car pull to one side under braking Will significantly increase brake pedal feel The absolute best bang for your buck, inexpensive brake upgrade around
Related products
-
Steering Link Bump Steer Spacers For Increased Accuracy
$15.99Quick ViewAdd to cartIncludes one pair each of .100″, .060″, .030″ spacers Increased accuracy to further adjust and reduce your bump steer, if needed One set does one car
-
GM Polyurethane Trailing Arm Bushings 1964-2002
$34.99Quick ViewAdd to cartSold in pairs When replacing upper trailing arms be sure to check the condition of your upper housing bushings Polyurethane offers a tighter suspension feel while still eliminating a moderate amount of road harshness New parts to replace worn and cracked factory rubber Fits >64-67 68-72 73-77 78-88 midsize A/G-Body cars, all 8 rear end …
-
1978-1988 A/G-Body Rear Trailing Arm Fastener Set
$22.99Quick ViewAdd to cartIncludes -8x Grade 8 1/2-13 bolts -8x Grade 8 1/2-13 nylon insert nuts -16x Grade 8 1/2 SAE flat washers All yellow zinc coated for rust prevention Torque to 75 lb/ft Note: The factory fastener size was 12mm, meaning the holes are a hair(<.020) smaller than the fasteners, a 1/2″ drill bit will make very …
Reviews
There are no reviews yet.