1978-1988 A/G-Body Rear Trailing Arm Fastener Set
$22.99
Includes
-8x Grade 8 1/2-13 bolts
-8x Grade 8 1/2-13 nylon insert nuts
-16x Grade 8 1/2 SAE flat washers
All yellow zinc coated for rust prevention
Torque to 75 lb/ft
Note: The factory fastener size was 12mm, meaning the holes are a hair(<.020) smaller than the fasteners, a 1/2″ drill bit will make very quick work of those holes and allow the install of these fasteners. Stock or otherwise M12 fasteners will work but our arms have 1/2″ ID bushing sleeves and holes.
| Weight | 3 lbs |
|---|
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
Related products
-
Hawk Performance Pads
$77.99Quick ViewAdd to cartDon’t upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your MPC brakes Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are …
-
Large Bore Clip-In Wheel Cylinders For GM Drum Brakes
$35.99Quick ViewAdd to cartSold as a pair Increases stopping power of stock drum brakes significantly and noticeably Direct replacement for any “Clip-type” GM wheel cylinder Known fitment includes but is not limited to: >1978-1988 A/G-Body (Metric Chassis) >1982-1992 F-Body (factory drum rear) >1982-1990 S-10 / Sonoma
-
1978-1988 A/G-Body Pre-Bent Stainless Steel Rear Hard Lines For Disc Brake Upgrade On Factory Rear
$44.99Quick ViewAdd to cart>Eliminates need to shorten factory lines >Pre-bent for a perfect fit >Pre-flared for a truly bolt on design >Stainless steel to last a lifetime Note: Must be used with the stainless braided line upgrade, standard hoses in the disc brake upgrade kit are too short *Actual part not shown
-
1978-1988 A/G-Body MCP Rear Disc Brake Kit Caliper Spacer Upgrade
$19.99Quick ViewAdd to cartAllows the caliper piston to remain square in its bore by taking up the difference between the caliper designed for 1″ rotors and the aftermarket .810″ thick rotor Results in more even pad wear and therefore longer pad life A must for expensive pads, protect your investment!
Reviews
There are no reviews yet.