1982-2002 2WD S-10 Large Bore Front Calipers
$149.99
Sold as a pair
Unidirectional, be sure to install the bleeder pointing up
Large bore front calipers have been redesigned to not only be lighter but stronger than the stock unit
These all new calipers deliver over 20% more clamping force at the rotor, much more than the popular but expensive “Blazer” upgrade
Maintaining stock dimensions allows serious brake power without needing to change to oversize wheels
Unlike almost every other front brake upgrade, these calipers are a direct bolt on. No machining or cutting required
Note: In very high heat applications we recommend removing the 4 O-rings in each caliper that ride on the slide pin
| Weight | 10 lbs |
|---|---|
| Dimensions | 8 × 8 × 8 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
1982-1990 2WD S-10 Basic Brake (Stock Drum Rear) Upgrade Kit
$105.99Quick ViewAdd to cartThe best bang for your buck brake upgrade on the market Replace old rubber hoses that can collapse and make the car pull when the brakes are applied (sound familiar?) Tighten up brake feel with DOT approved hoses that do not swell under pressure Larger bore clip-in wheel cylinders refresh and improve the stopping power …
1982-1990 2WD S-10 Basic Brake (Stock Drum Rear) Upgrade KitRead More
-
Semi-Metallic Pads
$22.99Quick ViewAdd to cartDont upgrade your entire brake system just to leave daily driver quality pads on your ride. Get the absolute most out of your brakes. Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are needed …
-
1991-2002 2WD S-10 DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)
$69.99Quick ViewAdd to cartA must for any vehicle with rubber hoses as they swell, reducing stopping power and making the car pull to one side under braking Will significantly increase brake pedal feel The absolute best bang for your buck, inexpensive brake upgrade around. NOTE: Check the wrench size of your front flare nuts (nut on the …
1991-2002 2WD S-10 DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)Read More
-
1991-2002 2WD S-10 Basic Brake (Factory Drum Rear) Upgrade Kit
$99.99Quick ViewAdd to cartThe best bang for your buck brake upgrade on the market Replace old rubber hoses that can collapse and make the car pull when the brakes are applied (sound familiar?) Tighten up brake feel with DOT approved hoses that do not swell under pressure Larger bore bolt-in wheel cylinders refresh and improve the stopping power …
1991-2002 2WD S-10 Basic Brake (Factory Drum Rear) Upgrade KitRead More
Related products
-
Large Bore Bolt-In Wheel Cylinders For GM Drum Brakes
$35.99Quick ViewAdd to cartSold as a pair Increases stopping power of stock drum brakes significantly and noticeably Direct replacement for any ~1.367″ bore backing plate that uses bolt-in wheel cylinder Known fitment includes but is not limited to: >1964-1967 A-Body >1968-1972 A-Body >1973-1977 A-Body >1977-1996 B-Body* >1970-1981 F-Body >1993-1997 F-Body >1968-1974 X-Body >1992-2002 S-10 Note: The oversize vs. …
Large Bore Bolt-In Wheel Cylinders For GM Drum BrakesRead More
-
1982-2002 2WD S-10 Adjustable Front Upper Control Arms
$524.99Quick ViewAdd to cartThe most affordable adjustable 2WD upper control arm on the market, in fact most competitors’ non adjustable arms are hundreds more 6061-t6 adjustment tubes Teflon (PTFE) lined chromoly rod ends for maximum life and minimum friction 7075 forged aluminum cross shaft Integral ball joint holder offers smaller and lighter packaging +1” Howe ball joints improve …
1982-2002 2WD S-10 Adjustable Front Upper Control ArmsRead More
-
1982-2002 2WD S-10 Steering Link Kit
$219.99Quick ViewAdd to cartTeflon (PTFE) lined chromoly rod ends for maximum life and minimum friction Half the weight of the factory tie rod assembly All needed fasteners included Replaces both inner and outer tie rods instead of just the outer like competitor pieces Black 6061-T6 Hard anodized adjustment tube A must to improve both cornering and straight line …
-
Large Bore Clip-In Wheel Cylinders For GM Drum Brakes
$35.99Quick ViewAdd to cartSold as a pair Increases stopping power of stock drum brakes significantly and noticeably Direct replacement for any “Clip-type” GM wheel cylinder Known fitment includes but is not limited to: >1978-1988 A/G-Body (Metric Chassis) >1982-1992 F-Body (factory drum rear) >1982-1990 S-10 / Sonoma
Reviews
There are no reviews yet.