No products in the cart.
Teflon (PTFE) lined chromoly rod ends for maximum life and minimum friction
Half the weight of the factory tie rod assembly
All needed fasteners included
Replaces both inner and outer tie rods instead of just the outer like competitor pieces
Black 6061-T6 Hard anodized adjustment tube
A must to improve both cornering and straight line driving by reducing or altogether eliminating toe changes throughout suspension travel
Invaluable for vehicles with increased caster or lowered ride height as it corrects the negative effects on bump steer from those changes
Comes with anti seize pre-applied to aid in adjustment and prevent galling
Zero drilling or machining needed, 100% bolt on
There are no reviews yet.
Only logged in customers who have purchased this product may leave a review.
Includes one pair each of .100″, .060″, .030″ spacers Increased accuracy to further adjust and reduce your bump steer, if needed
> Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc
This front only kit fills the need for S-10 trucks with rear end swaps such as the Ford 8.8 and 9″ Tighten up your brake pedal significantly and deliver more stopping power to your front calipers NOTE: Some trucks were offered with 1/4 front hard lines with 7/16-20 flare nuts, two Weatherhead PN 7828 adapters …
1982-2002 2WD S-10 DOT Approved Front Brake HosesRead More
Directly bolts in place of factory unit Aftermarket combination valve, for cars with rear disc brake upgrades Allows adjustment of rear pressure to better match the front brakes Comes with bleed tool included TOO MUCH REAR BRAKE CAN BE A SAFETY HAZARD
Sold as a pair Upgrade the look of your ride with our drilled and slotted slotted rotors Direct bolt on with simple installation steps Does include tone ring for vehicles equipped with ABS *These are NOT recommended for actual track use as high heat will cause cracking around the holes
>Fit stock front calipers for 1978-1988 A/G-Bodies, 1982-1992 F-Body front calipers, 1982-2002 2WD S-10 front calipers, and MCP rear disc upgrades for A/G-Bodies >Allows bleeding with only one person >Simply crack the bleeder as normal and it will allow fluid out but not suck air back in >Tighten when finished