1994-2002 S-10 Steering Shaft Assembly
$84.99
Eliminate the rubber rag joint that came stock on your 2nd gen S-10
Firm up your S-10s steering significantly and eliminate slop, all while making more room for your header tubes
A must for a vehicle with header clearance issues
Installs between the upper steering shaft and steering box
Interchanges with, and is more affordable than
-Hooker 71223021HKR
These U-joints are sealed and do not require grease. The plastic factory dust shield can be retained to keep dirt and other contaminates out of the assembly. An occasional shot of our rod end spray lube will keep them friction free for years.
| Weight | 3 lbs |
|---|---|
| Dimensions | 2 × 3 × 17 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Rod End Spray by WD-40
$9.99Quick ViewAdd to cart> Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc
Related products
-
Steering Link Bump Steer Spacers For Increased Accuracy
$15.99Quick ViewAdd to cartIncludes one pair each of .100″, .060″, .030″ spacers Increased accuracy to further adjust and reduce your bump steer, if needed One set does one car
-
1991-2002 2WD S-10 Basic Brake (Factory Drum Rear) Upgrade Kit
$99.99Quick ViewAdd to cartThe best bang for your buck brake upgrade on the market Replace old rubber hoses that can collapse and make the car pull when the brakes are applied (sound familiar?) Tighten up brake feel with DOT approved hoses that do not swell under pressure Larger bore bolt-in wheel cylinders refresh and improve the stopping power …
1991-2002 2WD S-10 Basic Brake (Factory Drum Rear) Upgrade KitRead More
-
1991-2002 2WD S-10 DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)
$69.99Quick ViewAdd to cartA must for any vehicle with rubber hoses as they swell, reducing stopping power and making the car pull to one side under braking Will significantly increase brake pedal feel The absolute best bang for your buck, inexpensive brake upgrade around. NOTE: Check the wrench size of your front flare nuts (nut on the …
1991-2002 2WD S-10 DOT Approved Stainless Steel Braided Brake Hose Kit (Factory Drum Rear)Read More
-
1982-2002 2WD S-10 Large Bore Front Calipers
$149.99Quick ViewAdd to cartSold as a pair Unidirectional, be sure to install the bleeder pointing up Large bore front calipers have been redesigned to not only be lighter but stronger than the stock unit These all new calipers deliver over 20% more clamping force at the rotor, much more than the popular but expensive “Blazer” upgrade Maintaining stock …
Reviews
There are no reviews yet.