Eliminate the rubber rag joint that came stock on your 2nd gen S-10
Firm up your S-10s steering significantly and eliminate slop, all while making more room for your header tubes
A must for a vehicle with header clearance issues
Installs between the upper steering shaft and steering box
Interchanges with, and is more affordable than
-Hooker 71223021HKR
These U-joints are sealed and do not require grease. The plastic factory dust shield can be retained to keep dirt and other contaminates out of the assembly. An occasional shot of our rod end spray lube will keep them friction free for years.
Weight | 3 lbs |
---|---|
Dimensions | 2 × 3 × 17 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Rod End Spray by WD-40
$9.99Quick ViewAdd to cart> Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc
Related products
-
1982-2002 2WD S-10 DOT Stainless Steel Braided Hose for MCP Rear Disc Kit Upgrade
$45.99Quick ViewAdd to cartA great upgrade to our rear brake kits, eliminating the rubber hose and replacing with stainless braided hose will significantly improve pedal feel by transferring braking power that was lost in the swelling of the rubber hose to the caliper
-
Replacement Standard Brake Pad MPC Rear Kit
$14.99Quick ViewAdd to cartStandard, affordable pad, that comes in our rear disc kit. Pads fit: >MPC rear disc brake kits >1982-2002 2WD S-10 front calipers >1982-2002 F-body front calipers >1978-1988 A/G-Body front calipers Note: Sold as an axle set, meaning two sets are needed to do the front and rear of the vehicle
-
Steering Link Bump Steer Spacers For Increased Accuracy
$15.99Quick ViewAdd to cartIncludes one pair each of .100″, .060″, .030″ spacers Increased accuracy to further adjust and reduce your bump steer, if needed One set does one car
-
GM U-Joint Steering Shaft Assembly ’79+
$109.99Quick ViewAdd to cartImportant: Verify your steering box input spline is 3/4-30 spine, if not it is most likely 13/16-30 spline which was ’77 and earlier Eliminate the worn rubber rag joint that came stock on your classic Firm up your steering significantly and eliminate slop, all while making more room for your header tubes A must for …
Reviews
There are no reviews yet.