1994-2002 S-10 Steering Shaft Assembly
$84.99
Eliminate the rubber rag joint that came stock on your 2nd gen S-10
Firm up your S-10s steering significantly and eliminate slop, all while making more room for your header tubes
A must for a vehicle with header clearance issues
Installs between the upper steering shaft and steering box
Interchanges with, and is more affordable than
-Hooker 71223021HKR
These U-joints are sealed and do not require grease. The plastic factory dust shield can be retained to keep dirt and other contaminates out of the assembly. An occasional shot of our rod end spray lube will keep them friction free for years.
| Weight | 3 lbs |
|---|---|
| Dimensions | 2 × 3 × 17 in |
Only logged in customers who have purchased this product may leave a review.
Product Enquiry
You may also like…
-
Rod End Spray by WD-40
$9.99Quick ViewAdd to cart> Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc
Related products
-
1991-2002 2WD S-10 Basic Brake (Factory Drum Rear) Upgrade Kit
$99.99Quick ViewAdd to cartThe best bang for your buck brake upgrade on the market Replace old rubber hoses that can collapse and make the car pull when the brakes are applied (sound familiar?) Tighten up brake feel with DOT approved hoses that do not swell under pressure Larger bore bolt-in wheel cylinders refresh and improve the stopping power …
1991-2002 2WD S-10 Basic Brake (Factory Drum Rear) Upgrade KitRead More
-
Universal Proportioning Valve
$42.99Quick ViewAdd to cartUniversal proportioning valve placed in-line with the rear hard line will modulate the rear brakes Rear brakes applying harder and locking before the front is extremely dangerous and when installed and adjusted right this helps to eliminate that
-
GM U-Joint Steering Shaft Assembly ’79+
$109.99Quick ViewAdd to cartImportant: Verify your steering box input spline is 3/4-30 spine, if not it is most likely 13/16-30 spline which was ’77 and earlier Eliminate the worn rubber rag joint that came stock on your classic Firm up your steering significantly and eliminate slop, all while making more room for your header tubes A must for …
-
Steering Link Bump Steer Spacers For Increased Accuracy
$15.99Quick ViewAdd to cartIncludes one pair each of .100″, .060″, .030″ spacers Increased accuracy to further adjust and reduce your bump steer, if needed One set does one car
Reviews
There are no reviews yet.