fbpx
Free Shipping on Orders $700+ (Continental 48)

GM U-Joint Steering Shaft Assembly ’79+

$109.99

Important: Verify your steering box input spline is 3/4-30 spine, if not it is most likely 13/16-30 spline which was ’77 and earlier

Eliminate the worn rubber rag joint that came stock on your classic

Firm up your steering significantly and eliminate slop, all while making more room for your header tubes

A must for a corner carver or even daily, feels like new again

Installs between the steering column and steering box

Simple install, an hours work with noticeable improvement

Fits G-Body’s, early S-10s, F-Body’s and more

These U-joints are sealed and do not require grease. The plastic factory dust shield can be retained to keep dirt and other contaminates out of the assembly. An occasional shot of our rod end spray lube will keep them friction free for years

IMPORTANT INSTALL INFO: If the u-joint does not slide over the column, chamfer the end of the column with a file until it does, you should not be hammering on this to install it. About 10% of columns need a slight amount of material removed

NOTE: Again please verify your column output is 1″ DD and steering box input is 3/4 x 30 Spline, if not we CAN modify to fit your application

NOTE: Late model S-10s have a u joint at the column from the factory, however if you wish to purchase this shaft to replace both that u-joint and the rag joint make a note in your order as we have to make this item longer

Weight 3 lbs
Dimensions 2 × 3 × 17 in

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Product Enquiry

You may also like…

  • Rod End Spray by WD-40

    $9.99
    Quick View

    > Dry spray eliminates the possibility of dirt and grit sticking to the bearing surface which prematurely wears rod ends > Contains Teflon to aid in friction reduction and prolonged life > Aids in AN hose assembly > Great for seat tracks, door hinges, carburator throttle shafts etc etc

    Add to cart